FRU information (service only)
Field Replacement Units (FRUs) should be replaced by
qualified service personnel only.
LED switch card
Before you begin:
• Read "Safety information" on page 196.
• Review the information in "Before you begin" on page
63.
1
Holding screws
2
LED switch card
To remove the LED switch card, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the top cover (see "Removing the server top
cover and bezel" on page 67).
4. Disconnect the switch card cables.
5. Remove the 4 holding screws.
6. Lift the switch card out of the server.
145