IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual page 38

3. Turn off the server and all attached devices and discon-
nect all external cables and power cords (see "Safety
information" on page 196); then remove the top cover.
4. Locate the battery on the system board (see "System
board component locations" on page 54).
5. Remove adapters as necessary so you can access the
battery. (See "Working with adapters" on page 68.)
6. Lift and remove the plastic dividers by pressing the
latches on the top ends of the dividers toward the divid-
ers and lifting the dividers from the server.
7. Remove the battery:
a. Use one finger to lift the battery clip over the bat-
tery.
b. Use one finger to slightly slide the battery toward
the rear of the server. The spring mechanism
behind the battery will push it out toward you as
you slide it forward.
c. Use your thumb and index finger to pull the bat-
tery from under the battery clip.
d. Ensure that the battery clip is touching the base of
the battery socket by pressing gently on the clip.
8. Insert the new battery:
a. Tilt the battery so that you can insert it into the
front of the socket, under the battery clip.
b. As you slide it under the battery clip, press the
battery down into the socket.
9. Reinstall any adapters that you removed.
10. Insert the plastic dividers into the divider guides.
11. Reinstall the top cover.
Note: You must wait approximately 20 seconds after
you plug the power cord of the server into an
electrical outlet before the power control button
becomes active.
12. Start the Configuration/Setup Utility program and set
configuration parameters as needed. Refer to "Using
the Configuration/Setup Utility program" on page 43.
26
Netfinity 6000R Type 8682 Models 1RY, 2RY