IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual page 101

To install a Netfinity 3-Pack Ultra160 Hot-Swap Expansion
Kit:
Attention: When you handle Electrostatic Discharge-Sensi-
tive devices (ESD), take precautions to avoid damage from
static electricity. For details on handling these devices, refer
to the following Web site and search for ESD:
http://www.ibm.com
1. Review the information in "Before you begin" on page
63 and in "Safety information" on page 196.
2. Turn off the server and peripheral devices and discon-
nect all power cords and external cables; then, remove
the top cover (see "Removing the server top cover and
bezel" on page 67).
3. Refer to the documentation that comes with the option
to assemble the hot-swap expansion option.
4. Align the hot-swap expansion option with the empty
slot at the rear of the optional hard disk drive cage,
adjacent to the standard hot-swap hard disk drive back-
plane.
5. Slide the hot-swap expansion option down into the
guides on the slot at the rear of the optional hard disk
drive cage, and secure it to the server with the blue
slide latch located on top of the optional hard disk drive
cage.
6. Refer to the documentation that comes with the option
to complete the installation of the option.
7. Install additional internal hot-swap hard disk drives in
the optional hard disk drive cage (see "Installing a hot-
swap hard disk drive" on page 76), and connect the
drives to the optional hot-swap backplane. You can
connect a maximum of three hot-swap hard disk drives
to the optional hot-swap backplane.
Note: If you connected these optional hot-swap hard
8. If you have other options to install or remove, do so
now; otherwise, go to "Installing the server top cover
and bezel" on page 91.
disk drives to the optional hot-swap backplane,
then the optional hot-swap backplane sets the
SCSI IDs for the optional hot-swap backplane
and the hot-swap hard disk drives. See "Setting
SCSI IDs" on page 97 for additional information.
Expansion backplane
Installing options
89