IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual page 44

Table 3. Novell NetWare or IntraNetWare ODI driver
messages for the Ethernet controller
PCNTNW-
NW-066
PCNTNW-
NW-071
PCNTNW-
NW-072
PCNTNW-
NW-073
PCNTNW-
NW-074
32
Netfinity 6000R Type 8682 Models 1RY, 2RY
The cable might be disconnected from
the adapter.
Explanation: The cable might be
disconnected from the server Ethernet
port.
Action: Verify that a cable is connected to
the Ethernet port.
The matching virtual adapter could not
be found.
Explanation: You tried to load another
instance of the driver with a different I/O
address. This new adapter could not be
found.
Action: Verify that you installed an IBM
Netfinity 10/100 Fault Tolerant Adapter
and make sure that the adapter is seated
correctly. If the adapter is seated
correctly, go to "Starting the diagnostic
programs" on page 17 to run the
diagnostic programs.
A resource tag is unavailable.
Explanation: The driver tried to allocate
some resources that were not available.
Action: Add more memory, or free some
memory resources in the server. Then,
restart the server.
Unable to allocate memory
Explanation: The driver failed to allocate
the memory needed for normal operation.
Action: Add more memory, or free some
memory resources in the server. Then,
restart the server.
The hardware interrupt cannot be set.
Explanation: An attempt was made to
initialize a given hardware interrupt. The
attempt was not successful.
Action: Verify that the Ethernet controller
is enabled. If the Ethernet controller is
enabled, go to "Starting the diagnostic
programs" on page 17 to run the
diagnostic programs. If you have an
Ethernet adapter installed, make sure that
the adapter does not share an IRQ with
any other device.