Installing A Hot-Swap Hard Disk Drive - IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual

1
Hard disk drive activity light (green)
2
Hard disk drive status light (amber)
3
SCSI hot-swap hard disk drive connector
Note: The hard-disk drive activity light and hard-disk drive
status light on the backplane match the hard-disk
drive activity light and hard-disk drive status light on
the front of the server (see "Start the server" on page
8).
The following illustration shows the rear connectors on the
hot-swap-drive backplane before the repeater card is
installed, as viewed from the rear of the server.
1
SCSI cable connector
2
SCSI power cable connector
3
I2C cable connector
Note: To install an additional hot-swap drive backplane on
the back of the server, see "Installing a Netfinity 3-
Pack Ultra160 Hot-Swap Expansion Kit" on page 87.

Installing a hot-swap hard disk drive

The following illustration shows how to install a hot-swap
hard disk drive.
Note: You do not have to turn off the server to install hot-
swap drives in these bays.
76
Netfinity 6000R Type 8682 Models 1RY, 2RY