IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual page 98

Note: The illustrations in this document might differ slightly
from your hardware.
1
Filler panel
2
AC power light
3
DC power light
4
Power supply handle
5
Power supply
To install an additional power supply:
1. Remove the filler panel.
2. Place the handle on the power supply in the open posi-
tion.
3. Slide the power supply into the chassis and close the
handle.
4. Plug the power cord into the power supply; then, into a
properly grounded electrical outlet.
5. Verify that the DC Power light and the AC Power light
on the power supply are lit, indicating that the power
supply is operating properly.
CAUTION:
86
Netfinity 6000R Type 8682 Models 1RY, 2RY