IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual page 95

1
Microprocessor slot 1 (J34)
2
Microprocessor slot 2 (J35)
3
Microprocessor slot 3 (J36)
4
Microprocessor slot 4 (J37)
5
Memory board (J40)
6
PCI slot 2 64-bit 66 MHz (J51)
7
PCI slot 3 64-bit 66 MHz (J52)
8
PCI slot 4 64-bit 66 MHz (J53)
9
PCI slot 5 64-bit 33 MHz (J54)
10 PCI slot 6 64-bit 33 MHz (J55)
11 PCI hot-plug switch card (J1)
12 PCI slot 1 32-bit 33 MHz (J50)
13 Battery
Note: For additional illustrations of the system-board com-
ponents, see "System board component locations" on
page 54.
The following illustration shows how to install a microproces-
sor on the system board.
Note: The illustrations in this document might differ slightly
from your hardware.
To install an additional microprocessor:
Attention: When you handle Electrostatic Discharge-Sensi-
tive devices (ESD), take precautions to avoid damage from
static electricity. For details on handling these devices, refer
to the following Web site and search for ESD:
http://www.ibm.com
Terminator card
Latch
Microprocessor
Latch
Installing options
83