Omron CJ1W-C113 - REV 02-2008 Operation Manual page 300

Memory Operation
Positions
Acceleration and
Deceleration Times
Dwell Times
Zones
Address
11F4
11F5
11F6
11F7
11F8
11F9
11FA
11FB
Note Addresses other than the above should be set to their default settings (0).
The origin search acceleration and deceleration times will be used for acceler-
ation and deceleration and so this data needs to be set completely to the
default settings (0).
Dwell times are not used in these programs, so this data area needs to be set
completely to the default settings (0).
Zones are not used in these programs, so this data area needs to be set com-
pletely to the default settings (0).
Setting
04B0 Position #0
0000
03E8 Position #1
0000
03E8 Position #2
0000
03E8 Position #3
0000
Section 10-2
Contents of setting
1,200 pulses (4B0 Hex)
1,000 pulses (3E8 Hex)
1,000 pulses (3E8 Hex)
1,000 pulses (3E8 Hex)
273