Toro TurfMaster HDX 22215 Service Manual page 221

Blade Break Arm Installation (continued)
30 Inch TurfMaster® HDX WPM
3432-730 Rev A
g302331
16. Install the transmission belt to the transmission pulley.
17. Using a 7/16 inch socket on the bottom of the transmission, release pressure
on the quarter inch screw driver. Remove the quarter inch screw driver,
allowing idler arm to put tension on the belt.
18. Install the 4 (1/4–20 inch) taptite screws securing the belt cover to the frame.
Torque screws to 55 ± 5 in-lbs. (6 ± 1 Nm).
g296175
19. Install the 1/4–20 inch taptite screw securing the frame cover to the frame.
Torque screw to 110 ± 11 in-lbs. (12 ± 2 Nm).
Figure 358
Figure 359
Page 7–95 Deck: Service and Repairs