Advertisement
Quick Links
TimeCutter
For All TimeCutter
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Note:
Determine the left and right sides of the machine from the normal operating position.
© 2018—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
HD Riding Mower
Description
No parts required
Rear hitch
Bolt (5/16 x 1 inch)
Locknut (5/16 inch)
No parts required
No parts required
Ignition key
Hose coupling (non-CE machines only)
Operator's Manual
Engine owner's manual (non-Toro
engines only)
Operator training material
Register at www.Toro.com.
®
HD Riding Mowers
Qty.
–
1
2
2
–
–
1
1
1
1
1
Form No. 3410-234 Rev C
Use
Connect the battery.
Install the rear hitch.
Set up the motion-control levers (CE
machines only).
Check the mower adjustment.
Complete the setup.
Original Instructions (EN)
All Rights Reserved *3410-234* C
Printed in the USA
Advertisement
Related Manuals for Toro TimeCutter HD Series
Summary of Contents for Toro TimeCutter HD Series
- Page 1 Check the mower adjustment. Ignition key Hose coupling (non-CE machines only) Operator's Manual Complete the setup. Engine owner’s manual (non-Toro engines only) Operator training material Note: Determine the left and right sides of the machine from the normal operating position.
- Page 2 Connecting the Battery No Parts Required Procedure Loosen the 2 fasteners on the battery cover counterclockwise 1/4 turn and remove the battery cover (Figure g197768 Figure 2 1. Hex bolt 4. Negative battery post cap 2. Washer 5. Nut 3. Negative battery cable 6.
- Page 3 Installing the Rear Hitch Setting Up the Motion-Control Levers Parts needed for this procedure: CE Machines Only Rear hitch Bolt (5/16 x 1 inch) No Parts Required Locknut (5/16 inch) Procedure Procedure Locate the motion-control levers attached, but Install the bracket to the frame as shown in Figure folded down on the machine.
- Page 4 Parts needed for this procedure: Ignition key Hose coupling (non-CE machines only) Operator's Manual Engine owner’s manual (non-Toro engines only) Operator training material Checking the Tire Pressure Check the front and rear tires for proper inflation; refer to Checking the Tire Pressure in the Operator’s Manual for the recommended inflation pressure.