Toro TurfMaster HDX 22215 Service Manual page 187

Front Bumper Assembly (continued)
30 Inch TurfMaster® HDX WPM
3432-730 Rev A
g298931
7. Slightly raise the axle weldment and install bushing on the bottom for the
non-height-of-cut side of the axle weldment. Install the other bushing for the
top of the non-height-of-cut side of the axle weldment. Install the (7/16 inch)
bolt and nut securing the bushing to the axle weldment until finger tight, do
not fully tighten fastener. Repeat for opposite side.
Note: Install the 5/16–18 inch bolts in the following order:
Non-height-of-cut lower 5/16–18 inch bolt and nut
Height-of-cut lower 5/16–18 inch bolt and nut
Height-of-cut upper 5/16–18 inch bolt and nut
Non-height-of-cut upper 5/16–18 inch bolt and nut
g298928
8. Install the 5/16–18 inch bolt and nut to both ends of the front bumper
assembly. Torque all bolts to 140 ± 5 in-lbs. (15.8 ± 0.5 Nm).
Figure 291
Figure 292
Page 7–61 Deck: Service and Repairs