Toro TurfMaster HDX 22215 Service Manual page 174

Height-of-Cut Installation (continued)
Deck: Service and Repairs
g297894
17. Put anti-seize inside the axle bearing before sliding over the shaft. Install the
axle bearing housing assembly over the axle. Line up the mounting hole
on the bearing housing assembly to the weldment hole. Install the bearing
retainers into the rear axle weldment and rear height-of-cut plate for alignment
purposes before securing the transmission to the frame. Install the 5/16–18
inch bolt to the axle weldment. Torque bolt to 160 ± 16 in-lbs. (18 ± 2 Nm).
g297061
18. Install LH 5/16–18 inch nut to carriage bolt and the RH 5/16–18 inch taptite
screw to the main frame securing the transmission assembly to the main
housing. Torque nut to carriage bolt to 140 ± 5 in-lbs. (16 ± 0.5 Nm). Torque
taptite screw to 160 ± 16 in-lbs. (18 ± 2 Nm).
Figure 265
Figure 266
Page 7–48 30 Inch TurfMaster® HDX WPM
3432-730 Rev A