Toro TurfMaster HDX 22215 Service Manual page 169

Height-of-Cut Installation (continued)
30 Inch TurfMaster® HDX WPM
3432-730 Rev A
g298697
5. Install the height-of-cut plate to the main frame.
Note: The spring is inside the frame.
6. Install the 2 (5/16–18 inch) bolts on the RH side of the height-of-cut plate.
Torque bolts to 160 ± 16 in-lbs. (18 ± 2 Nm).
g298694
7. Install the engine cage to the chassis.
8. Install the 6 (5/16–18 inch) nuts to carriage bolt securing the engine cage to
chassis. Torque nuts to 140 ± 15 in-lbs. (15.8 ± 1.7 Nm).
Figure 255
Figure 256
Page 7–43 Deck: Service and Repairs