Store - HP 64751 User Manual

store

This command lets you save the contents of specific memory locations in an
absolute file. You also can save trace memory contents in a trace file.
The store command creates a new file with the name you specify, if there is not
already an absolute file with the same name. If a file represented by <FILE>
already exists, you must decide whether to keep or delete the old file. If you
respond with yes to the prompt, the new file replaces the old one. If you respond
with no, the store command is canceled and no data is stored.
The transfer address of the absolute file is set to zero.
The parameters are as follows:
--EXPR-- This is a combination of numeric values, symbols, operators, and parentheses,
specifying a memory address. See the EXPR syntax diagram.
FCODE
The function code used to define the address space being referenced. See the syntax
diagram for FCODE to see a list of the function codes available and for an
explanation of those codes.
<FILE> This represents a file name you specify for the absolute file identifier or trace file
where data is to be stored. If you want to name a file beginning with a number, you
must precede the file name with a backslash (\) so the system will recognize it as a
file name.
Chapter 11: Emulator/Analyzer Interface Commands
store
409