Table of Contents
Advertisement
Chapter 11: Emulator/Analyzer Interface Commands
copy
noheader
This copies the information into a file without headings.
pod_command
This allows you to copy the most recent commands sent to the HP 64700 Series
emulator/analyzer.
printer
This option specifies your system printer as the destination device for the copy
command. Before you can specify the printer as the destination device, you must
define PRINTER as a shell variable. For example, you could enter the text shown
below after the "$" symbol:
$ PRINTER=lp
$ export PRINTER
If you don't want the print message to overwrite the command line, execute:
$ set PRINTER = "lp -s"
registers
This allows you to copy a list of the contents of the emulation processor registers to
the selected destination. The copy register command is not allowed when the
emulator is configured for real-time runs and is running the user program. With no
options specified, the basic register class is copied.
<REGISTER>
Specifies the name of an individual register. Refer to the "Accessing Registers"
section in the "Using the Emulator" chapter for a list of the register names and
classes.
software
This option lets you copy a list of the current software breakpoints to a selected
_breakpoints
destination.
status
This allows you to copy emulation and analysis status information.
--SYMB--
This option represents the symbol whose children are to be listed. See the
--SYMB-- syntax diagram and the Symbolic Retrieval Utilities User's Guide for
information on symbol hierarchy.
thru_line_number
Specifies the last line number of the trace list to include in the copied range.
to
This allows you to specify a destination for the copied information.
trace
This lets you copy the current trace listing to the selected destination. Trace
information is copied in the same format as specified in the last display trace
command. Initial values are the same as specified by the last display trace
command.
346
Advertisement
Table of Contents
