Chapter 12: Error Messages
Terminal Interface Messages
Action: Retry the operation. If breaks are occurring continuously, you may wish to
disable some of the break conditions.
901
Invalid firmware for emulation subsystem
Cause: This error occurs when the HP 64700 system controller determines that the
emulation firmware (ROM) is invalid.
Action: This message is not likely to occur unless you have upgraded the ROMs in
your emulator. Be sure that the correct ROM is installed in the emulation controller.
902
Invalid analysis subsystem; product address: %s
Cause: This error occurs when the HP 64700 system controller determines that the
analysis firmware (ROM) is invalid.
Action: This message is not likely to occur unless you have upgraded the ROMs in
your emulator. Be sure that the correct ROMs are installed in the analyzer board.
903
Invalid ET subsystem; product address: %s
Cause: Detects an invalid ET. Used only internally.
904
Invalid auxiliary subsystem; product address: %s
Cause: For future products.
911
Lab firmware for emulation subsystem
Cause: This message should never occur. It shows that you have an unreleased
version of emulation firmware.
912
Lab firmware analysis subsystem; product address: %s
Cause: This message should never occur. It shows that you have an unreleased
version of analysis firmware.
913
Lab firmware subsystem; product address: %s
Cause: This message should never occur. It shows that you have an unreleased
version of system controller firmware.
474