HP 64751 User Manual page 466

Chapter 12: Error Messages
Terminal Interface Messages
READY is false, it indicates that one or more of the instruments participating in the
measurement is running in the monitor.
Action: None, information only.
612
Write to ROM break
Cause: This status message will be printed if you have enabled breaks on writes to
ROM and the emulation processor attempted a write to a memory location mapped
as ROM.
Action: None (except troubleshooting your program).
613 Analyzer Break
Cause: Status message.
614
Guarded memory access break
Cause: This message is displayed if the emulation processor attempts to read or
write memory mapped as guarded.
Action: Troubleshoot your program; or, you may have mapped memory incorrectly.
615 Software breakpoint: %s
Cause: This status message will be displayed if a software breakpoint is
encountered during a program run. The emulator is broken to the monitor. The
string %s indicates the address where the breakpoint was encountered.
616
BNC trigger break
Cause: This status message will be displayed if you have configured the emulator
to break on a BNC trigger signal and the BNC trigger line is activated during a
program run. The emulator is broken to the monitor.
617
CMB trigger break
Cause: This status message will be displayed if you have configured the emulator
to break on a CMB trigger signal and the CMB trigger line is activated during a
program run. The emulator is broken to the monitor.
466