To Display The Trace - HP 64751 User Manual

Chapter 7: Using the Emulation Analyzer
The Basics of Starting, Stopping, and Displaying Traces

To display the trace

• Choose Trace→Display or Display→Trace.
• Using the command line, enter the display trace command.
You can display captured trace data with the display trace command. The
available options to the display trace command are described in the "Modifying
the Trace Display" section later in this chapter.
Examples
To display the trace:
display trace <RETURN>
The first column in the trace list contains the line number. The trigger is always on
line 0.
The second column contains the address information associated with the trace
states. Addresses in this column may be locations of instruction opcodes on fetch
cycles, or they may be sources or destinations of operand cycles.
The third column shows mnemonic information about the emulation bus cycle.
228