HP 64751 User Manual page 470

Chapter 12: Error Messages
Terminal Interface Messages
651 Unable to configure break on software breakpoints
Cause: The emulator controller cannot enable breakpoints, possibly because the
emulator is in an unknown state or because of a hardware failure.
Action: Initialize the emulator or cycle power, then re-enter the command. If the
same failure occurs, call your HP sales and service office.
653
Break condition configuration aborted
Cause: Occurs when <CTRL>c is entered during the configuration of break
conditions.
661
Software breakpoint break condition is disabled
Cause: You have attempted to set or clear a software breakpoint when software
breakpoints are disabled.
Action: You must enable software breakpoints before you can set them.
663 Specified breakpoint not in list: %s
Cause: You tried to clear a software breakpoint that was not previously set. The
string %s prints the address of the breakpoint you attempted to clear.
Action: You must first set a software breakpoint before it can be cleared.
664 Breakpoint list full; not added: %s
Cause: The software breakpoint table is already reached the maximum of 32
breakpoints. The breakpoint you just requested, with address %s, was not inserted.
Action: Clear breakpoints that are no longer in use. Then, set the new breakpoint.
665
Enable breakpoint failed: %s
Cause: System failure or target condition.
Action: Check memory mapping and configuration questions.
666 Disable breakpoint failed: %s
Cause: System failure or target condition.
Action: Check memory mapping and configuration questions.
470