State Qualifiers
Whenever a state can be specified in the trace command (trigger state, storage state,
prestore state, etc.), you will see the following softkeys that allow you to qualify the
state:
address
The value following this softkey is searched for on the lines that
monitor the emulation processor's address bus.
data
The value following this softkey is searched for on the lines that
monitor the emulation processor's data bus.
status
The value following this softkey is searched for on the lines that
monitor other emulation processor signals.
When a value is specified without one of these softkeys it is assumed to be an
address value.
Predefined Values for Qualifiers When you specify status qualifiers for
analyzer states (by pressing the status softkey), you will be given the following
softkeys which are predefined values for the qualifiers.
Chapter 7: Using the Emulation Analyzer
Qualifying Trigger and Store Conditions
235