HP 64751 User Manual page 544

Chapter 15: Installation
Installing Sun SPARCsystem Software
Installing Sun SPARCsystem Software
This section shows you how to install the Graphical User Interface on Sun
SPARCsystem workstations. These instructions also tell you how not to install the
Graphical User Interface if you want to use just the conventional Softkey Interface.
This section shows you how to:
1
2
3
4
5
Step 1. Install the software from the media
The tape that contains the Graphical User Interface software may contain several
products. Usually, you will want to install all of the products on the tape.
However, to save disk space, or for other reasons, you can choose to install selected
filesets.
If you plan on using the conventional Softkey Interface instead of the Graphical
User Interface, you can save about 3.5 megabytes of disk space by not installing the
XUI suffixed filesets. (Also, if you choose not to install the Graphical User
Interface, you will not have to use a special command line option to start the
Softkey Interface.)
Refer to the Software Installation Notice for software installation instructions.
After you are done installing the software, return here.
544
Install the software from the media.
Start the X server and OpenWindows.
Set the necessary environment variables.
Verify the software installation.
Map your function keys.