Table of Contents
Advertisement
Chapter 15: Installation
Installing Hardware
Installing Hardware
This section describes how to install emulation and analysis hardware and how to
connect the emulator probe to the demo target system.
Equipment supplied
The minimum system contains:
•
•
•
•
Optional parts are:
•
•
•
Equipment and tools needed
In order to install and use the 68340 emulation system, you need:
•
Installation overview
The steps in the installation process are:
1
2
3
4
5
Your emulation and analysis system may already be assembled (depending on how
parts of the system were ordered).
510
HP 64751A 68340 PGA Emulator Probe (which includes the demo target
system).
HP 64748C Emulation Control card.
HP 64704A 80-Channel Emulation Bus Analyzer card.
HP 64700 Card Cage.
HP 64171A 256 Kbyte Memory Modules or HP 64171B 1 Mbyte Memory
Modules (0 wait state emulation memory through 16.7 MHz, 1 wait state
above 16.7 MHz).
HP 64172A 256 Kbyte Memory Modules or HP 64172B 1 Mbyte Memory
Modules (0 wait state emulation memory through 25 MHz).
HP 64173A 4 Mbyte Memory Modules (0 wait state emulation memory
through 22 MHz, 1 wait state above 22 MHz).
Flat-blade screwdriver.
Connect the HP 64751 emulator probe to the HP 64748C emulator control card.
Install cards into the HP 64700 card cage.
Install emulation memory modules on the emulator probe.
Connect the emulator probe to the demo target system.
Apply power to the HP 64700.
Advertisement
Table of Contents
