Table of Contents
Advertisement
cannot fit into one 4 Kbyte range, you must map one of the ranges to single-port
emulation memory.
143
Dual ported memory in use by foreground monitor
Cause: You attempted to map an address range to the 4 Kbyte block of dual-port
emulation memory when it has already been allocated to the foreground monitor.
Action: When using a foreground monitor, only single-port emulation memory is
available when mapping memory.
144
Dual ported memory not mapped to <abs_file_address_range> for
downloaded monitor
Continuing with default foreground monitor
Cause: You attempted to load a custom foreground monitor absolute file whose
address range does not agree with the range defined in response to the "Monitor
address?" configuration question. The second message tells you the default
foreground monitor, resident in the emulator firmware, continues to be used.
Action: Either assemble and link your foreground monitor at the address specified
during configuration or change the answer to the "Monitor address?" configuration
question so that it agrees with the monitor program absolute file.
145
Downloaded monitor spans multiple 4K byte block boundaries
Cause: You attempted to load a custom foreground monitor absolute file that does
not fit into one 4 Kbyte address range.
Action: Edit your foreground monitor program source file so that it fits into one
4 Kbyte address range.
146
Monitor must be mapped on a 4K byte boundary
Cause: You attempted to define a foreground monitor base address that is not on a
4 Kbyte boundary.
Action: Specify the monitor program base address that is on a 4 Kbyte boundary
(in other words, ending in 000H).
Chapter 12: Error Messages
Terminal Interface Messages
457
Advertisement
Table of Contents
