HP 64751 User Manual page 435

Chapter 12: Error Messages
Graphical/Softkey Interface Messages - Unnumbered
Could not create <CONFIGURATION BINARY FILENAME>
Cause: The system could not create a binary emulation configuration file (file.EB).
Action: Check the file.EB write permission and verify that the specified directory
exists and is writeable.
Could not exec configuration process
Cause: The host system could not fork the configuration process or could not
execute the configuration process.
Action: Make sure that the host system is operating properly, and that all Softkey
Interface files were loaded properly during the installation process. Try starting the
emulation session again.
Could not load default configuration
Cause: The host system could not load the default configuration into the emulator.
Action: Cycle power on the emulator and run the Terminal Interface "pv"
(performance verification) command on the emulator to verify that it is functioning
properly. Also, verify proper software installation. If loading default configuration
still fails, then call your HP 64000 representative.
<CONFIGURATION FILENAME> does not exist
Cause: The configuration file you are trying to load does not exist.
Action: Try the load configuration command again using a valid configuration file
name.
Don't care number unexpected
Cause: While defining an expression in your command, you included a don't care
number (a binary, octal, decimal, or hexadecimal number containing "x"), which
was not expected. Don't care numbers are not valid for all commands. See the
EXPR command syntax for more information about expressions.
Emulation analyzer defaulted to delete label
Cause: Analyzer trace labels were changed or modified while labels were in use in
the trace specification.
435