Table of Contents
Advertisement
Chapter 6: Using the Emulator
Executing User Programs
A reset command followed by a run command will load the interrupt stack pointer
and program counter values specified during configuration into the emulation
processor and run from the loaded program counter value. This is true for both
background and foreground monitors.
To run programs until an address
• Position the mouse pointer in the entry buffer and enter the address you want to run
from; then, choose Execution→Run→until ().
• Using the command line, enter the run until <address> command.
When you run until an address, a software breakpoint is set at the address and the
program is run from the current program counter.
When using the command line, you can combine the various types of run
commands; for example, you can run from the transfer address until another
address.
Examples
To run from the transfer address until the address of the global symbol main:
run from transfer_address until address main <RETURN>
To stop (break from) user program execution
• Choose Execution→Break.
• Using the command line, enter the break command.
This command generates a break to the background monitor.
176
Advertisement
Table of Contents
