The parameters are as follows:
measurement
This causes the system to pause until a pending measurement completes (a trace
_complete
data upload process completes), or until a <CTRL>c signal is received. If a
measurement is not in progress, the wait command will complete immediately.
or
This causes the system to wait for a <CTRL>c signal or for a pending measurement
to complete. Whichever occurs first will satisfy the condition.
seconds
This causes the system to pause for a specific number of seconds.
<TIME>
This prompts you for the number of seconds to insert for the delay.
Examples
wait <RETURN>
wait 5; wait measurement_complete <RETURN>
Chapter 11: Emulator/Analyzer Interface Commands
wait
427