Executing User Programs; To Run Programs From The Current Pc - HP 64751 User Manual

Chapter 6: Using the Emulator

Executing User Programs

Executing User Programs
You can use the emulator to run programs, break program execution into the
monitor, step through the program by high-level source lines or by assembly
language instructions, and reset the emulation processor.
When displaying memory in mnemonic format, a highlighted bar shows the current
program counter address. When you step, the mnemonic memory display is
updated to highlight the new program counter address.
When displaying resisters, the register display is updated to show you the contents
of the registers after each step.
You can open multiple interface windows to display memory in mnemonic format
and registers at the same time. Both windows are updated after stepping.
This section describes how to:
•
•
•
•

To run programs from the current PC

• Choose Execution→Run→from PC.
• Using the command line, enter the run command.
When the emulator is executing the user program, the message "Running user
program" is displayed on the status line.
174
Start the emulator running the user program.
Stop (break from) user program execution.
Step through user programs.
Reset the emulation processor.