HP 64751 User Manual page 461

163
Update HP64740 firmware to version A.02.02 or newer
Cause: The HP 64751 emulator requires version A.02.02 or newer of the analyzer
firmware.
Action: Refer to the "Updating Emulator/Analyzer Firmware" section in the
"Installation" chapter.
168
Can't access module regs, addr space mask (@sd bit 6) is set
Cause: You have attempted to modify the MBAR or CF_MBAR register with a
value that masks supervisor data space by setting bit 6. The HP 64751 emulator
requires an address space to access 68340 SIM registers and, therefore, doesn't let
you set bit 6 in the MBAR or CF_MBAR register.
Action: Modify the MBAR or CF_MBAR registers with values that do not set bit 6.
168
Can't access module regs, mbar (@sd bit 6) is set
Can't access module regs, cf_mbar (@sd bit 6) is set
Cause: These errors occur if the user program sets bit 6 of the MBAR register
(whose contents can be copied into the CF_MBAR register with the
sync_sim_registers to_m68340_sims command) and the emulator needs to access
other SIM or emulator configuration registers.
Action: Modify the MBAR or CF_MBAR registers with values that do not set bit 6.
177
BDM communication failed
Cause: There was some problem with the serial communication interface with the
emulation processor's Background Debug Mode (BDM).
Action: Initialize the emulator or cycle power. Then reenter the command. If the
same failure occurs, call your HP sales and service office.
178
Unable to run performance verification tests
Cause: The emulator was unable to run the performance verification tests.
Action: Make sure the emulator probe is connected correctly and that all cables are
secured. Make sure that the emulator probe is plugged into the demo target system
and that the demo target system power cable is connected to the HP 64700.
Chapter 12: Error Messages
Terminal Interface Messages
461