Table of Contents
Advertisement
Chapter 12: Error Messages
Terminal Interface Messages
412
Retry limit exceeded, transfer failed
Cause: The limit for repeated attempts to send a record during a transfer operation
was exceeded, therefore the transfer was aborted.
Action: Retry the transfer. Make sure you are using the correct command options
for both the host and the HP 64700. The data communications parameters need to
be set correctly for both devices. Also, if you are in a remote location from the
host, it is possible that line noise may cause the failure.
413
Transfer failed to start
Cause: Communication link or transfer protocol incorrect.
Action: Check link and transfer options.
415
Timeout, receiver failed to respond
Cause: Communication link or transfer protocol incorrect.
Action: Check link and transfer options.
600
Adjust PC failed during break
Cause: System failure or target condition.
Action: Run performance verification (Terminal Interface pv command), and
check target system.
602
Break failed
Cause: The break command was unable to break the emulator to the monitor.
Action: Determine why the break failed, then correct the condition and retry the
command. See message 608.
603
Read PC failed during break
Cause: System failure or target condition.
Action: Try again.
604
Disable breakpoint failed: %s
Cause: System failure or target condition.
464
Advertisement
Table of Contents
