Qualifier - HP 64751 User Manual

QUALIFIER

The QUALIFIER parameter is used with trace only, trace prestore, TRIGGER,
and trace counting to specify states captured during the trace measurement.
You may specify a range of states or specific states to be captured. You can
continue to "or" states until the analyzer resources are depleted. You can use only
one "range" statement in the entire trace command.
You can include "don't care numbers." These contain an "x" preceded and/or
followed by a number. Some examples include 1fxxh, 17x7o, and 011xxx10b.
"Don't care numbers" may be entered in binary, octal, or hexadecimal base.
Expression types are "address" when none is chosen. The default is to qualify on
all states.
The parameters are as follows:
address The value following this softkey is searched for on the lines that monitor the
emulation processor's address bus. This is the default, and is therefore not required
on the command line when specifying an address expression.
and
This lets you specify a combination of status and expression values when status is
specified in the state specification.
Chapter 11: Emulator/Analyzer Interface Commands
QUALIFIER
391