Chapter 12: Error Messages
Terminal Interface Messages
686
Stepping aborted; number steps completed: %d
Cause: This message is displayed if a break was received during a step command
with a step count greater than zero. The break could have been due to any of the
break conditions or a <CTRL>c break. The number of steps completed is displayed.
688
Step display failed
Cause: System failure or target condition.
Action: Check memory mapping and configuration questions.
689
Break due to cause other than step
Cause: An activity other than a step command caused the emulator to break. This
could include any of the break conditions or a <CTRL>c break.
692
Trace error during CMB execute
Cause: System failure.
Action: Run performance verification (Terminal Interface pv command).
693
CMB execute; run started
Cause: This status message is displayed when you are making coordinated
measurements. The CMB /EXECUTE pulse has been received; the emulation
processor started running at the address specified by the specify run command.
Action: None; information only.
694
Run failed during CMB execute
Cause: System failure or target condition.
Action: Run performance verification (Terminal Interface pv command), and
check target system.
700
Target memory access failed
Cause: This message is displayed if the emulator was unable to perform the
requested operation on memory mapped to the target system.
472