HP 64751 User Manual page 467

618
trig1 break
Cause: This status message will be displayed if you use the break_on_trigger
syntax of the trace command and the analyzer has found the trigger condition while
tracing a program run. The emulator is broken to the monitor.
619 trig2 break
Cause: This status message will be displayed if you have used the internal trig2
line to connect the analyzer trigger output to the emulator break input and the
analyzer has found the trigger condition. The emulator is broken to the monitor.
620
Unexpected software breakpoint
Cause: If you have enabled software breakpoints, this message is displayed if a
software breakpoint instruction is encountered in your program that was not
inserted by a modify software_breakpoints set command and is therefore not in
the breakpoint table.
Action: Remove the breakpoint instructions in your code before assembly and link,
and use the modify software_breakpoints set command to reinsert them after the
program is loaded into memory.
621 Unexpected step break
Cause: System failure.
Action: Run performance verification (Terminal Interface pv command).
622 %s
Cause: Monitor specific message.
623 CMB execute break
Cause: This message occurs when coordinated measurements are enabled and an
EXECUTE pulse causes the emulator to run; the emulator must break before
running.
Action: This is a status message; no action is required.
Chapter 12: Error Messages
Terminal Interface Messages
467