Table of Contents
Advertisement
Chapter 11: Emulator/Analyzer Interface Commands
load
load
This command transfers absolute files from the host computer into emulation or
target system RAM. With other parameters, the load command can load emulator
configuration files, trace records, trace specifications, or symbol files.
The absolute file contains information about where the file is stored. The memory
map specifies that the locations of the file are in user (target system) memory or
emulation memory. This command also allows you to access and display
previously stored trace data, load a previously created configuration file, and load
absolute files with symbols.
Note that any file specified by <FILE> cannot be named "configuration",
"emul_mem", "user_mem", "symbols", "trace", or "trace_spec" because these are
reserved words, and are not recognized by the emulator/analyzer interface as
ordinary file names.
The absolute file is loaded into emulation memory by default.
The parameters are as follows:
configuration
This option specifies that a previously created emulation configuration file will be
loaded into the emulator. You can follow this option with a file name. Otherwise
the previously loaded configuration will be reloaded.
374
Advertisement
Table of Contents
