HP 64751 User Manual page 434

Chapter 12: Error Messages
Graphical/Softkey Interface Messages - Unnumbered
Configuration process QUIT
Cause: The configuration process ended because <CTRL> "\" (SIGQUIT signal)
was encountered. This is an easy way to exit configuration without saving any
changes.
Action: Try starting the emulation session again. If the problem persists, you may
need to cycle power on the emulator.
Connecting to <LOGICAL NAME>
Cause: This is a status message. The host system is making a communication
connection to the emulator whose logical name is defined in
/usr/hp64000/etc/64700tab.net or /usr/hp64000/etc/64700tab.
Continue load failed
Cause: The host system could not continue the previous emulation session because
it could not load the continue file.
Action: Try again. If the failure continues, call your HP Service Representative.
Continuing previous session, continue file loaded
Cause: This is a status message. An emulation session which was ended earlier
with the end command has been restarted. The host system reported that the session
was continued (using settings from the previous session) and that the continue file
loaded properly.
Continuing previous session, user interface defaulted
Cause: The previous emulation session was continued and the Softkey Interface
was set to the default state.
Could not create default configuration
Cause: The host system could not create a default configuration for the emulation
session.
Action: Check disk space under /usr/hp64000 and verify proper software
installation.
434