Table of Contents
Advertisement
Chapter 11: Emulator/Analyzer Interface Commands
log_commands
log_commands
This command allows you to record commands that are executed during an
emulation session.
A command file is an ASCII file containing Softkey Interface commands. The
interface can read a command file and execute its commands as if they were typed
into the command line. Simply type the filename on the command line.
This interface command lets you create command files by logging. When the
interface is in logging mode, all commands entered and executed on the command
line are also copied to the named file. Once started, logging continues until either
logging is turned off or the emulation session is ended.
The log_commands command is not on the softkeys. You must type it into the
command line to access the remainder of the log_commands softkeys.
The parameters are as follows:
<FILE>
This represents the file where you want to store interface commands. If the file does
not exist, a new file is created. If the file already exists, the new commands are
appended to the present content in the file, unless the noappend option is specified.
off
This option stops command logging.
noappend
If the named file is an existing file, this option causes the new commands to
overwrite any information present in the file. If this option is not specified, new
commands are appended to the existing contents of the file.
376
Advertisement
Table of Contents
