To Change The Count Qualifier - HP 64767 User Manual

Emulation/analysis
Table of Contents

Advertisement

Chapter 7: Using the Emulation Analyzer
Qualifying Trigger and Store Conditions

To change the count qualifier

• Use the counting option in the trace command.
After initializing the analyzer, the default count qualifier is "off". When counting is
turned OFF, up to 1024 states can be stored in the trace.
When you count states, the counter is incremented each time the state is captured
(not necessarily stored) by the analyzer. When a state is counted, up to 512 states
can be stored in the trace.
You can only count time reliably if the processor clock speed is less than or equal
to 16 MHz. When time is counted, up to 512 states can be stored in the trace.
211

Advertisement

Table of Contents
loading

This manual is also suitable for:

80186/8/xl/ea/eb

Table of Contents