Table of Contents
Advertisement
Disassembly Guide
Alarm Speaker Removal/Replacement
Removal
78
11. Connect the speaker cable to J12 of the User Interface PCB.
12. Connect the CCFL wire harness with two white wires to J5 of the User
Interface PCB.
13. Connect the Display PCB ribbon cable to J13 of the User Interface PCB.
Install the clip over the J13 connector.
14. Complete the procedure in paragraph Monitor Assembly on page 66.
1. Complete the procedures in paragraphs Prior to Disassembly on page 64, and
Monitor Disassembly on page 65.
2. Disconnect the speaker wire harness from J12 on the User Interface PCB
(Figure 13).
Advertisement
Table of Contents
