Table of Contents
Advertisement
Replacement
N-595
5. Remove and discard the used double-sided tape.
6. Install new double-sided tape as shown in Figure 11.
7. Slide the Display PCB into the grooves in the top case. Check to make sure
the Display PCB is firmly seated in the top case. Apply pressure between the
top case and the display PCB to make good contact with the double-sided
tape.
8. Connect the CCFL wire harness with two white wires to J5 of the User
Interface PCB.
Figure 11: Display PCB
Disassembly Guide
75
Advertisement
Table of Contents
