Table of Contents
Advertisement
Replacement
N-595
3. Use needle-nose pliers to disconnect the leads from the PEM (see Figure 8).
Figure 8: Power Entry Module
4. Reconnect the three power supply leads as indicated in Table 11 on page 71.
5. Install the PEM in the bottom case with the fuse drawer facing down. A tab in
the bottom case holds the PEM in place. Insert the bottom wing of the PEM
between the tab and the internal edge of the sidewall of the bottom case. Push
the PEM down and towards the outside of the monitor until it clicks into
place.
6. Complete the procedure in paragraph Monitor Assembly on page 66.
Disassembly Guide
69
Advertisement
Table of Contents
