Table of Contents
Advertisement
Data Port Interface Protocol
SETUP
NEXT
NEXT
COMM
SELECT
EXIT
Language Selection
108
1. Turn on the N-595 by pressing the ON/STANDBY button.
2. Press the SETUP softkey.
3. Press the NEXT softkey.
4. Press the NEXT softkey.
5. Press the COMM softkey.
6. Press the SELECT softkey.
7. Use the ADJUST UP and ADJUST DOWN buttons to select the desired
protocol.
8. Press the EXIT softkey set the protocol. The protocol setting will be in effect
until the monitor is powered off.
Note:
The protocol setup for the monitor may be saved as institutional default
settings. See Setting Institutional Defaults (Sample) on page 47. Use care
when performing this procedure because all settings will be saved as
institutional default settings.
Eleven languages can be viewed on the screen and sent to the printer. The
languages are ENGLISH, DANSK (Danish), FRANCAIS (French), DEUTSCH
(German), ITALIANO (Italian), ESPANOL (Spanish), NEDERLANDS (Dutch),
NORSK (Norwegian), PORTUG (Portuguese), SUOMI (Finnish), and SVERIGE
(Swedish).
1. Turn on the N-595 by pressing the ON/STANDBY button.
Advertisement
Table of Contents
