QUICK GUIDE TO OPERATION
Basic Operation
Alarm Functions
Pulse Tone Volume
BASIC OPERATION
1.
Select the appropriate NELLCOR sensor and apply it to
the patient, following sensor directions for use. Connect the
sensor to the patient module.
2.
Plug the N-200 into a properly grounded AC outlet using a
hospital-grade power cord. Alternatively, operate the N-200
on its internal battery. Turn on the system: switch the
ON/STDBY switch to the ON position.
3.
For C-LOCK
appropriate ECG signal source to the N-200.
4.
Check alarm limits. If necessary, adjust them to suit the
patient's needs.
ALARM FUNCTIONS
Check Alarm Limits
Press the appropriate alarm button (HIGH SAT, LOW SAT,
HIGH RATE, or LOW RATE). When the button is pressed, the
selected limit will show in the display.
Adjust Alarm Limits
Press the appropriate alarm button (HIGH SAT, LOW SAT,
HIGH RATE, or LOW RATE), and turn the control knob until
the desired setting appears.
®
ECG synchronization, connect an
7