Communication Baud Rate - Nellcor OxiMax N-595 Service Manual

Data Port Interface Protocol

Communication Baud Rate

SETUP
NEXT
NEXT
106
- - - - BACK (back to Setup menu)
- - - - EXIT (back to Main menu)
- - - NCALL (Nurse Call)
- - - - NORM +
- - - - NORM -
- - - - BACK (back to Setup menu)
- - - - EXIT (back to Main menu)
- - - NEXT
- - - - ANALOG
- - - - -
- - - - -
- - - - -
- - - - BACK (back to Setup menu)
- - - - EXIT (back to Main menu)
- - - BACK (back to Setup menu)
- - BACK (back to Setup menu)
- EXIT (back to Main menu)
The baud rate may need to be changed to match the abilities of the attached
equipment. Perform the following procedure to change the baud rate to 2400,
9600, or 19200.
Note: When setting the communication protocol to AGILENT, SPACELBS,
MARQ, or DATEX the communication baud rate is automatically set to
the applicable baud rate.
1. Turn on the N-595 by pressing the ON/STANDBY button.
2. Press the SETUP softkey.
3. Press the NEXT softkey.
4. Press the NEXT softkey.
AGILENT (HP Agilent monitors)
SPACELBS (Spacelabs monitors)
MARQ (GE Marquette monitors)
DATEX (Datex-Ohmeda AS/3 monitor)
0 VOLT
1 VOLT
STEP