Disassembly Guide
Cooling Fan Removal/Replacement
Removal
72
Caution: When installing the Power Supply, tighten the seven screws to a
maximum of 4 inch-pounds. Over-tightening could strip out the screw holes
in the bottom case, rendering it unusable.
10. Install the seven screws in the Power Supply and tighten.
11. Connect the fan harness to J1 on the Power Supply.
12. Install the PEM in the bottom case with the fuse drawer facing down. A tab in
the bottom case holds the PEM in place. Insert the bottom wing of the PEM
between the tab and the internal edge of the sidewall of the bottom case. Push
the PEM down and towards the outside of the monitor until it clicks into
place.
13. Complete the replacement procedure in paragraph Monitor Assembly on
page 66.
1. Complete the procedure in paragraphs Prior to Disassembly on page 64, and
Monitor Disassembly on page 65.
2. Disconnect the fan wire harness from J1 on the Power Supply PCB (see
Figure 10).