Monitor Disassembly
N-595
1. Complete the procedure in paragraph Prior to Disassembly on page 64.
2. Set the N-595 upside down, as shown in Figure 5.
3. Remove the monitor's four corner screws.
Caution: Observe ESD (electrostatic discharge) precautions when
disassembling and reassembling the N-595 and when handling any of the
components of the N-595.
4. Separate the monitor's top case from the bottom case of the monitor, being
careful not to stress the wire harnesses between the cases. Place the two
halves of the monitor on the table as shown in Figure 6.
5. Disconnect the monitor's Power Supply harness from J16 on the User
Interface PCB.
Figure 5: Corner Screws
Disassembly Guide
65