Alarm Speaker Removal/Replacement; Removal - Nellcor OXIMAX N-595 Service Manual

Disassembly Guide
Alarm Speaker

Removal/

Replacement
Removal
66
11. Connect the speaker cable to J12 of the User Interface PCB.
12. Connect the CCFL wire harness with two white wires to J5 of the User
Interface PCB.
13. Connect the Display PCB ribbon cable to J13 of the User Interface PCB.
Install the clip over the J13 connector.
14. Complete the procedure in paragraph Monitor Assembly page 54.
1. Complete the procedures in paragraphs Prior to Disassembly page 52,
and Monitor Disassembly page 53.
2. Disconnect the speaker wire harness from J12 on the User Interface PCB
(Figure 16 on page 67).
3. Pull the holding clip back from the speaker and lift the speaker out of the
top case.