Cable Routing, Upper Module Rack - GE Datex-Ohmeda Aisys Carestation Reference Manual

Aisys

6.11 Cable routing, upper module rack

Battery Backup for 12 inch AM Display
Cables run behind
rear cosmetic panel
Auxiliary
Connector
Board
AC Mains
6-16
The following diagram shows typical cable connections for Aisys machines
with an upper module rack. Refer to the individual sections showing proper
routing of the cables through the machine.
Note In general, route the cables through the machine as shown in the following
sections. Connect each end to the intended connector. Ensure that the cable
is properly restrained and positioned so that it does not interfere when
replacing covers or with the motion of the Display arm. Store excess cable
length within the machine.
F-CU8 (Rev 10)
Display Connector Board
Lower Electrical Cabinet
MGAS
Cables run behind
left side panel.
15 inch AM Display
Control Bar
DU
Cables through ARM
04/08 M1046983