Inserting The Contactor Truck In A Panel - Siemens NXAIR Operating Instructions Manual

Operating the contactor panel with panel width 600 mm

14.18 Inserting the contactor truck in a panel

180
CAUTION
Injury
The mechanism inside the contactor truck can cause injuries by getting squeezed,
caught or cut.
Do not remove any parts of the covering.
CAUTION
Maloperation
Protruding parts at the rear of the contactor truck can cause injuries or material
damage.
Move and operate the contactor truck only at the front side.
CAUTION
Maloperation
The contactor truck is designed exclusively for slow and careful driving on
obstacle-free paths.
Before moving the contactor truck, check the path.
Keep the shunting area and paths free of obstacles and dry.
Remove objects such as small parts, installation material or tools from the
floor in the travel area.
Move the contactor truck only slowly and constantly.
The contactor truck is not suitable for unsteady floor, such as stairs,
deepening or floor joints.
NOTICE
Maloperation
The locking bracket at the contactor truck is exclusively designed for interlocking
the contactor truck with the switchgear frame.
As long as the contactor truck is not completely moved into the panel, the
locking indication at the locking bracket must show UNLOCKED!
Operate the locking bracket only if the contactor truck has been
completely moved into the panel.
Do not push the locking bracket downwards towards LOCK if
•
the contactor truck is outside the panel.
•
the contactor truck is moved only partially into the panel.
NXAIR / ≤ 40 kA
110-0134.9 / 14