Inserting The Contactor Truck In A Panel - Siemens NXAIR Operating Instructions Manual

Pull the contactor truck at the top of the front cover (1) onto the ramps (2).
Keep pulling the contactor truck until it is outside of the panel. By doing so, the low-voltage
connection is separated automatically.
Fig. 231: Pulling the contactor truck
If no further operation is executed: Close the high-voltage door.
✓
The contactor truck is taken out of the panel.

13.17 Inserting the contactor truck in a panel

110-0134.9 / 14
Operating the contactor panel with panel width 435 mm
CAUTION
Injury
The mechanism inside the contactor truck can cause injuries by getting squeezed,
caught or cut.
Do not remove any parts of the covering.
CAUTION
Maloperation
Protruding parts such as locking elements at the contactor truck or at the rear of
the contactor truck can cause injuries.
Move and operate the contactor truck only at the front side.
NXAIR / ≤ 40 kA
1
2
Fig. 232: Contactor truck taken out of the
panel
133