Mounting The Device To A Panel - Siemens SIMATIC NET RUGGEDCOM RX5000 Equipment Manual

2.
3.
4.
2.3.2

Mounting the device to a panel

For panel installations, the RUGGEDCOM RX5000 can be equipped with adapters pre-
installed on each side of the chassis. The adapters allow the device to be attached to
a panel using screws.
To mount the device to a panel, do the following:
1.
RUGGEDCOM RX5000
Equipment Manual, 11/2023, C79000-G8976-1058-15
3
1
3
1
Rear
1
Front
2
Mounting brackets
3
Figure 2.1 Mounting brackets
If required, install mounting brackets on the opposite side of the device to
protect from vibrations.
Insert the device into the rack.
Secure the mounting brackets to the rack using the supplied hardware.
Place the device against the panel and align the adapters with the mounting
holes.
Installing the Device
2.3.2 Mounting the device to a panel
2
2
17