Siemens NXAIR Operating Instructions Manual page 132

Operating the contactor panel with panel width 435 mm
Moving contactor truck outside of the panel
To move the contactor truck outside of the panel, use two handles.
Fig. 229: Handle on contactor truck
132
CAUTION
Maloperation
The contactor truck is designed exclusively for slow and careful driving on
obstacle-free paths.
Before moving the contactor truck, check the path and the ramps.
Keep the shunting area, paths and ramps free of obstacles and dry.
Remove objects such as small parts, installation material or tools from the
floor in the travel area.
Move the contactor truck only slowly and constantly.
The contactor truck is not suitable for unsteady floor, such as stairs,
deepening or floor joints.
CAUTION
Protruding parts
Protruding parts such as locking elements at the contactor truck or at the rear of
the contactor truck can cause injuries.
Move and operate the contactor truck only at the front side.
NXAIR / ≤ 40 kA
Fig. 230: Moving the contactor truck using two
handles
110-0134.9 / 14